TB24 Yandina Trollbridge24 Battery Combiner
TB24
Replaced with the Trollbridge 24 Smart Shore by Hypertech
The Yandina Trollbridge24 Combiner allows you to charge your 24 volt trolling motor battery from the 12 volt alternator on your main engine or trailer hook-up. It works by automatically putting two 12 volt batteries in series when you need to run the trolling motor and in parallel for charging. It is bi-directional so when not trolling, the trolling booster battery backs up your starting or house battery.
The Trollbridge24 is suitable for installations with alternators up to 100 amps and 24 volt trolling motors up to 85 amps. For larger installations you can use the Trollbridge2400 for 200 amp alternators and motor up to 500 amps.
WARNING: Cancer and reproductive harm. Visit www.p65warnings.ca.gov
FEATURES
-
Fully automatic, no switches or connectors to change
-
Both batteries operate in parallel when not trolling
-
The bottom battery can be used as a house or starting battery even when trolling
-
The two trolling batteries do not have to be matched or balanced
- Lithium compatible with matched Lithium batteries
-
A single output 12 volt charger will change all batteries
-
Works with minimal 2 battery systems or in conjunction with a house battery
-
Can be conveniently located with the batteries
-
Rated for 12 volt alternators up to 100 amps
-
Rated for 24 volt trolling motors up to 85 amps
-
Green LED indicates 24 volt output active
- Compact. 4" long including mounting tabs, 2" wide, 1.5" high (plus cables)
-
Charging is done at 12 volts so your motor never sees charging voltages
-
Over 99% efficient - faster charge - no wasted power- no heating
-
Waterproof rated IP68 Protected from long term immersion
-
Ignition rated for explosive atmospheres
-
No voltage drop so batteries reach full charge
-
No voltage drop so motor gets full power
-
No wasted power, no heat sink or cooling required
-
No modification to alternator or 12 volt engine wiring
-
Simple 5 wire basic installation
-
Comes with all cables for basic hookup
-
Draws no current when off - no on/off switch needed
-
No diodes to burn out if accidentally shorted
-
Withstands ambient temperature to over 175 F (80 C) for engine compartment mounting
