C100 Yandina Two Bank 75 Amp Battery Combiner 12 volt, 24 volt, Lead Acid, Lithium

The Yandina combiner 100 is a voltage-sensing relay (13.3 volts or 26.6 volts) which connects two batteries together when either is receiving a charge. When the charging ceases, the relay opens so that each battery operates independently. Supplemental battery banks can be added by using an additional combiner for each bank. You never have to worry about switching to "both" when your engine is running and forgetting to switch back to save your starting battery from discharge when you stop.

WARNING: Cancer and reproductive harm. Visit www.p65warnings.ca.gov

Features

• 75 amps continuous rating, 400 amps closing current (2 seconds), 100 amps for 5 minutes
• Suitable for alternators up to 100 amps, up to 18 volts. Larger charging sources should use the Combiner 200
• Waterproof rated IP68 Protected from long term immersion
• No voltage drop so batteries reach full charge
• Electronic thermal monitoring with shutdown and automatic restart
• Minimal wasted power, no heat sink or cooling required
• Can be used on alternators with internal or external regulators
• Alternators with external voltage sense require no special wiring
• Simple basic installation, two battery wires and ground
• Complete with all cables and terminals for basic hookup
• Green LED indicates when combined
• Red LED indicates temporary thermal overload shutdown
• Draws no current when batteries are not being charged
• Draws less than 150 milliamps when charging is in progress
• Optional external remote control for off, automatic, on
• Remote ON can be used for assisted engine starting
• Remote OFF can be used to disable the combiner
• Withstands ambient temperature to over 175 F for exposed or engine compartment mounting
• No diodes to burn out if accidentally shorted
• Compact - only 2.5 wide including tabs by 1 5/16" thick by 1.5 high (plus cables)